Numerical tunnel stability analysis (case study of Qom metro tunnel

Document Type : Case Study

Author

Department of Civil Engineering, Faculty of Technical Engineering, North Tehran Branch, Islamic Azad University, Tehran, Iran

Abstract
The stability of underground structures is a complex and difficult issue due to changes in rock and soil types, geological structure, regional stress conditions, excavation stages, and the creation of underground space from one location to another. Therefore, it is necessary to investigate the stability status of the structure in question by using different stability analysis methods, comparing the results obtained from them, and also using appropriate engineering judgment. The purpose of this research is to analyze the stability of Tunnel A of Qom Metro under the influence of static and dynamic loads. For this purpose, the studied environment has been modeled using Plaxis finite element software and using the plane strain theory with 15-node elements. By performing the geotechnical study of the area and considering the desired tunnel cross-section, it was possible to change the structural characteristics as well as the seismic environment. The results show that by increasing the thickness of the initial tunnel lining, the applied displacements decreased by 0.5% and the applied forces increased. It should be noted that by increasing the thickness of the tunnel lining from 20 cm to 35 cm, the tunnel floor has been decreased by about 100%, but this difference is less in other studied points.

Keywords

Subjects
Davoud Jafari, Mehran Khalaj, Pazman Salehi (2023) Designing a Stable Model for Tehran Metro
Train Scheduling with a Robust Optimization Perspective Scientific Journal of Software Computing.
Persian.
Kordestani ،Reza و Shahriar ،Kurosh و Maarefvand ،Parviz (2013) Stability analysis of Qods Square
Station, Line 1 of Tehran Metro, according to the considered excavation method using PLAXIS software
Quarterly Journal of Analytical and Numerical Methods in Mining Engineering. Persian.
Sattar Azami (2013) "Stability Analysis and Design of Sardasht Long Tunnel Support System"
Master's Thesis in Rock Mechanics Engineering, Isfahan University of Technology, Faculty of Mining.
Persian.
Mahdori, Sattar and Esmaeili, Erfan and Abedi, Amirsalar, (2019), Numerical modeling and stability
analysis of shallow tunnels using finite difference method, 7th National Conference on Applied
Research in Civil Engineering, Architecture and Urban Management and 6th Specialized Exhibition of
Housing and Building Manufacturers in the Province. Persian.
Vojoudi, Mehdi (2003), Investigation of the effect of earthquake on underground structures with a
special focus on tunnels and underground metro stations, International Research Institute of Seismology
and Earthquake Engineering. Persian.
Hashash, Y.M.A and Hook, J.J. and Schmidt, B. and I-Chiang Yao, J. (2001), “Seismic design and
analysis of underground structures”, Tunnelling and Underground Space Technology, 16, pp 247-293.
Yuan, Z., Xu, C., Cai, Y., Cao, Z., (2015) Dynamic response of a tunnel buried in a saturated
poroelastic soil layer to a moving point load. Soil Dynamics and Earthquake Engineering 77, PP: 348 –
359.
Shen, Y., GAO, B., Yang, X., Tao, S., (2014) Seismic damage mechanism and dynamic deformation
characteristic analysis of mountain tunnel after Wenchuan earthquake. Engineering Geology 180, PP:
85–98.
Walter Amberg and Marco Russo,(2001) “Seismic design of underground structures the bolu
tunnel”, Lombardi SA Engineering Limited,Via Simen 19,CH – 6648 Minusio, Switzerland.
Hesami, S., Ahmadi, S. (2013) Ground Surface Settlement Prediction in Urban Areas due to Tunnel
Excavation by the NATM. Electronic Journal of Geotechnical Engineering. Vol. 18.
Rajaee, A., Abrishsmi, S., Javankhoshdel, S., & Dastpak, P(2024). Soil Strength Parameters
Sensitivity Analysis of Tied-Back Urban Deep Excavation, 77th Canadian Geotechnical Conference,
GeoMontreal, Canada,
Ghodratnama, M., Rajaee, A., Masoodi, A. R., Abrishami, S., Davarpanah, T. A., & Pournoori, P.
(2025). Enhancing the fracture toughness of eco-friendly self-compacting concrete with waste glass
coarse aggregates and steel fibers: A mixed-mode I/II fracture analysis using SCB specimens.
Theoretical and Applied Fracture Mechanics, 104969
  • Receive Date 14 June 2025
  • Revise Date 16 June 2025
  • Accept Date 22 July 2025
  • First Publish Date 22 July 2025
  • Publish Date 23 September 2025